Get an instant labor, material, and permit cost range for a residential plumbing job. Built on the same takeoff math plumbing crews use in PipeMaster on the jobsite.
Sinks, toilets, tubs, showers, and appliance hookups.
US residential rates typically run $75–$200 per hour.
Fill in your project details and hit Estimate cost to see a labor, material, and permit breakdown.
Most residential plumbers in the United States bill $75 to $200 per hour, with licensed journeyman rates in major metros closer to $150 to $250. Emergency and after-hours calls typically add a 1.5x to 2x multiplier plus a trip charge.
A three-fixture bathroom rough-in and trim-out usually runs 20 to 26 labor hours. At a $125 hourly rate that is roughly $2,500 to $3,300 in labor before fixtures, valves, and permit fees.
A like-for-like 50-gallon tank swap is commonly $1,400 to $2,600 installed. Converting to tankless, relocating the unit, or upsizing the gas line pushes the total higher because it adds venting and gas piping work.
Most jurisdictions require a permit for water heater replacement, repipes, and any new drain, waste, or vent piping. Simple faucet, trap, or fixture repairs are usually exempt. Permit fees in this estimator use typical residential ranges of $180 to $400.
Real pricing depends on access, wall and slab conditions, pipe material, local code amendments, and your market's labor rates. Use this figure to sanity-check a quote, then get a licensed plumber on site for a firm number.
PipeMaster gives plumbing crews voice job updates, pipe sizing, water heater sizing, drainage slope, and material takeoffs — all from a phone with wet hands.
See how PipeMaster works